• Day 1: Basics of measurement technology

Day 1 of the imc "Test & Measurement Days"

Basics of measurement technology

On the first day of the seminar series, the basics of measurement technology are discussed. You will get a practical and condensed summary of physical fundamentals, sensors, data acquisition and analysis, as well as an overview of current trends.

Agenda and course contents:

10:00 - 10:15 am

Reception & Greeting

10:15 - 12:00

Introduction to physical measurement technology
(Dr. Holger Knopp, imc Test & Measurement GmbH)

  • Introduction to test & measurement
    • Definition of the term "measurement"
    • System of units and basic values
    • Basic subdivision of metrology
  • Sensor basics
    • Principle operation of sensors
      • Temperatures
      • Pressure
      • Force, acceleration
  • Principles of data acquisition
    • Basics of AD conversion
      "Infinite world - finite place after data acquisition"
      • Resolution and dynamics
      • Sample rate selection and sampling theorem

12:00 - 1:00 pm

Lunch break - You're invited

1:00 - 1:50 pm

Determining measurement uncertainty
(Dr. Holger Knopp, imc Test & Measurement GmbH)

  • Basics for determining measurement uncertainty with the Monte-Carlo method
  • Examples of identifying measurement uncertainty influences when interpreting measurement results
1:50 - 2:00 pm Break

2:00 - 3:00 pm

Measurement data and evaluations
(Dr. Holger Knopp, imc Test & Measurement GmbH)

  • Visualization possibilities for measurement data
  • Viewing and analyzing serial measurements
  • Typical post-processing of measurement data
  • Creating test reports
  • Measurement data management

from 3:00 pm

Networking & Exchange

 

 

Top